1
Connect Device
Plug your Pico 2W into this computer via USB. The device must be running RelayKVM firmware with security support.
Not connected
2
Device Status
Security Status:
Unknown
3
Setup Shared Secret
This will generate a new shared secret. You'll need to press the BOOTSEL button on your Pico to confirm.
Current secret (browser):
-
Clear browser secret to connect without authentication (e.g., for old firmware).
4
Test Challenge-Response
Test the authentication without needing Bluetooth. This uses the same crypto that BLE will use.
5
Test via Bluetooth
Test the challenge-response authentication over BLE. This verifies the security works wirelessly.
Note: You can disconnect USB after pairing - the secret is stored on the device.
Note: You can disconnect USB after pairing - the secret is stored on the device.
Not connected
Log